Cyclone Thick Bleach 12x750ml

CLEANING AND DISINFECTING TOILETS: Flush first and remove excess dirt and grime before cleaning and disinfecting. Wet all surfaces of bowl interior, including sides of bowl and under the rim, with at least 100ml of bleach. Do not close the toilet bowl lid. To ensure disinfection allow to stand for at least 15 minutes. Brush entire bowl thoroughly and flush. To remove tough stains: Apply a generous amount of liquid directly onto the tough stain.

FOR HARD SURFACES: Remove heavy soiling first, then dilute 1:50 parts of water (20ml per 1lt of warm water). Apply with a sponge or mop, wetting all surfaces thoroughly. Allow to stand for 5 minutes, then wipe away excess. For Coronavirus, dilute 23ml per 1lt of water for 1,000 ppm and clean surfaces with a detergent first, prior to disinfection.

BLEACHING LAUNDRY: Dilute 1:100. If soaking overnight use 1:200 solution.

EQUIPMENT DISINFECTION BY SOAKING: Remove heavy soiling first, then dilute 1:50 parts water (20ml per 1lt of warm water). Allow to soak for a minimum of 15 minutes. Remove and rinse with water.

USAGE: Do not use on: Marble, natural stone, wood, painted surfaces, aluminium, carpet or paper. Please take care when handling product to avoid spillages on skin and clothes. Do not store near acid based products.
_____

Physical Hazard

Not Classified

Health Hazard

H314 - Causes severe skin burns
H318 - Causes serious eye damage

Environmental Hazard

H400 - Very toxic to aquatic life

_____

Disclaimer:

Evans Vanodine International products are designed for the professional market and are not intended for sale into the retail market or use by the public. Evans Vanodine International or Select Catering Solutions Limited will not be liable for any injury or consequential damage that arises because of the supply of professional use products into the retail/public sector and the failure to use the correct procedures and PPE when using Evans products.

Important Note: All information listed above is taken from the manufacturer product specification and should be completely tested by the users to ensure the product is correct for end use.